Reweaving

There are two different types of reweaving,  Inweaving and Thread Weaving. Prices for these kinds of repairs start at $125 and up. This price covers the smallest of repairs, usually a hole approximately 1/4″ by 1/4″ depending on the coarseness of the weave. This is a very intensive type of work and does not come easily. It takes great skill and is usually reserved for clothing of high quality or sentimental value.

reweaving, inweaving, thread weaving, invisible mending, reconstruction

Inweaving is used for most repairs. It can be done in much larger areas. The method used is to take a piece of cloth from some hidden area of the garment, unravel the edges and weave each separate thread into the cloth over the hole.  Afterward, the new piece of cloth is anchored to the garment so it can’t be pulled out. This type of repair can also be quite invisible but certain patterns and types of wool will not weave well. Gaberdine is one of the worst and I do not reweave gaberdine as 9 times out of 10 the customer is very dissatisfied. Also, many garments are disqualified for this repair as there is no excess material hidden anywhere. Places the material can be found are: inside pockets, at the back of the neck or interior of the jacket, in the zipper area, or inside of cuffs. This type of weave can also be quite invisible but not as much as thread weaving. As I am weaving a square piece of cloth over the damage there is a faint outline of the square around the repair. Often this line sinks into the cloth and is not noticeable. If the wool is very hard and tight it is more likely to show the line. In the example of gaberdine, the line is extremely noticeable.  Most wools lend well to type of repair though and often seem to completely disappear.

Thread weaving is done on the smallest of holes. In this process, each thread is meticulously replaced and the original pattern is woven to make the repair practically invisible. This repair is suitable for most woolens, though very sheer and light colors can show the repair because of the thickness caused by doubling threads in that area. Therefore it is not recommended for these types of materials. It is normally done only when a very small amount of threads are involved.